This website uses our own cookies and those of third parties so you have a better experience as a user. If you continue navigating, we consider you accept their usage. You can obtain more information about the cookies of this website by clicking here.

Ecco bit

  1. The machine will not turn on by clicking the red on button.
  2. The key has a lot of burr on finishing the duplicate.
  3. The measurements of the duplicate keys are not correct
  4. The size of the duplicate keys are not correct even though the depth adjustment has been carefully executed there is a difference between the head and tip of the key.
  1. The machine will not turn on by clicking the red on button.

    1. check that the power is correct. Check that the power cord is connected correctly. Check that fuses in the power point are intact. In the event that there has been a power outage, switch off and switch on the machine using the back switch as the circuit breaker on the machine may have tripped. Remember that for safety when carrying out any revision of the points mentioned here the machine must be off.

    Top

  2. The key has a lot of burr on finishing the duplicate.

    The cutter is worn, replace with a new cutter.

    Top

  3. The measurements of the duplicate keys are not correct

    Check that the depth and lateral adjustment are well executed on the machine. check the adjustment section of the user manual. Ensure that the two keys are positioned in the same way in the vice, either using the stops with the positioner or using the stop tips on the keys. The probe and the cutter have the same angle, so it is very important to always use original jma cutter and probe parts.

    Top

  4. The size of the duplicate keys are not correct even though the depth adjustment has been carefully executed there is a difference between the head and tip of the key.

    Check that the vices are well supported in their slide position, there are no chips interfering with their support. Check whether the key support is correct and there are no chips on the back of the key or inside the vice causing the key not to rest properly. Check that the support surface of the key on the vice is correct. heavy duty use over a long period of time may cause the vice to wear out. in this case, replace the vice. vices are replaced in pairs to ensure proper alignment.

    Top

  5. Top

Logotipos de iqnet y aenor