This website uses our own cookies and those of third parties so you have a better experience as a user. If you continue navigating, we consider you accept their usage. You can obtain more information about the cookies of this website by clicking here.

Dakar

  1. The green side indicator of the machine does not light up
  2. The green side indicator is on but the machine light does not come on when the switch is operated
  3. The depths of the duplicate keys are not correct
  4. The size of the duplicate keys is not correct even though the depth adjustment has been carefully executed. there are lateral differences between the head and tip of the key.
  5. The motor has no cutting power and stops when cutting.
  6. The motor works at high speed (ii), but not at low speed (r)

  1. The green side indicator of the machine does not light up

    Check that the rear switch of the machine is in the ON position (I) Check that the power is correct. Check that the power cord is connected correctly. Check the status of the fuses in the power point. Remember that for safety when carrying out any revision of the points mentioned here the machine must be off.

    Top

  2. The green side indicator is on but the machine light does not come on when the switch is operated

    The front bulb is fused or broken. Replace with another 12-volt bulb. (See manual)

    Top

  3. The depths of the duplicate keys are not correct

    Do not apply excessive force when duplicating the key. Exert the same pressure that has been used for adjusting, otherwise if there is excess force on the probe the duplicate will be too deep. Check that when carrying out the depth adjustment the probe is without the spring system. If you notice any looseness in the probe, contact technical support.

    Top

  4. The size of the duplicate keys is not correct even though the depth adjustment has been carefully executed. there are lateral differences between the head and tip of the key.

    This indicates that the grip on the vice is crooked. This can happen when you make a change of grip on the vice. (Refer to the manual and follow the grip adjustments instructions). Check that the key is well supported and there are no chips on the spine of the grip that makes the key rest badly. If the vice on the side of the cutter is badly damaged, replace it following the adjustment directions that come with the new grips, using the adjustment tools. Check that the support surface of the key on the vice is not worn out through use.

    Top

  5. The motor has no cutting power and stops when cutting.

    Check if the cutter is very worn. If the cutter is in good cutting condition the motor brushes may have worn. Replace the motor or call the technical service.

    Top

  6. The motor works at high speed (ii), but not at low speed (r)

    If necessary change the power board that regulates the motor speed. Contact technical support.

    Top

Logotipos de iqnet y aenor

© JMA Uk. All rights reserved.