This website uses our own cookies and those of third parties so you have a better experience as a user. If you continue navigating, we consider you accept their usage. You can obtain more information about the cookies of this website by clicking here.

Dakki

  1. The machine will not turn on by clicking the red on button.
  2. The depths of the duplicate keys are not correct
  3. The sizes of the duplicate keys are not correct even though the depth adjustment has been carefully executed. there are side differences between the head and tip of the key.
  4. The motor has no cutting power and stops when cutting.

  1. The machine will not turn on by clicking the red on button.

    Check that the power is correct. Check the status of the fuses that are in the power point. Remember that for safety when carrying out any revision of the points mentioned here the machine must be off.

    Top

  2. The depths of the duplicate keys are not correct

    Do not apply excessive force when duplicating the key. exert the same pressure that has been used for adjusting, otherwise if there is excess force on the probe the duplicate will be too deep. Check that when carrying out the depth adjustment the probe is without the spring system. if you notice any looseness in the probe contact technical support.

    Top

  3. The sizes of the duplicate keys are not correct even though the depth adjustment has been carefully executed. there are side differences between the head and tip of the key.

    This indicates that the grip is crooked. check that the cutter and the probe can get into the holes in the vice. if not contact technical support. Check that the key is well supported and there are no chips on the spine of the grip that makes the key rest badly. If the vice on the side of the cutter is badly damaged, replace it following the adjustment directions that come with the new grips. Check that the support surface of the key on the vice is not worn out through use.

    Top

  4. The motor has no cutting power and stops when cutting.

    Check if the cutter is very worn. If the cutter is in good cutting condition the motor brushes may have worn. replace the motor or call the technical service.

    Top

Logotipos de iqnet y aenor

© JMA Uk. All rights reserved.